The equipment may be used in zone 2 with flammable gases.The area in which the equipment is used should be a minimum of Pollution degree 2, as defined by IEC 60664-1 (that is, the environment should not contain conductive pollution and the equipment shall be installed in an indoor or sheltered location).Install the ControlWave Micro within a suitable certified tool-accessible ATEX or IECEx-approved IP54 or better enclosure.The USB connector on the IEC 62591 module shall not is used unless the area is known to be nonhazardous (non-flammable).When using Ethernet connections, the RJ45 (Ethernet) connection must have a mating connector with a valid securing clip to prevent loosening or disconnection during use.Connections made to RS-232 or RS-485 communications ports shall be mechanically secured in place with suitable screw connections to prevent loosening or disconnection during use. For full cautions and descriptions of installation and troubleshooting procedures, refer to that manual.ĬontrolWave Micro Special Conditions for Safe Use Use this safe use instruction (SUI) document with the control wave Micro Process Automation Controller Instruction Manual (part D301392X012).
0 Comments
Leave a Reply. |